tadda
Well-Known Member
- Thread starter
- #1
Just wanted to share this...
I recently replaced my rear console cubby with NVSpecialities direct replacement carbon fiber piece...
Very easy install and fitment was excellent...Also the cubby CF matches the CF on the front console perfectly...
Installation instructions:
Step 1- Remove inner rubber piece of cup holder
Step 2- Remove both torx screws from bottom of cup holder
Step 3- Pull up on entire cup holder piece to pop out clips
Step 4- Once cup holder piece is out you can remove factory cubby
Step 5- Factory cubby gator clips on back side need to be transferred to the new carbon cubby before installation
Step 6- Once clips are installed, carbon cubby can be pushed into factory spot
Step 7- Put cup holder piece back into place
Step 8- Fasten both torx screws and install inner rubber piece
I recently replaced my rear console cubby with NVSpecialities direct replacement carbon fiber piece...
Very easy install and fitment was excellent...Also the cubby CF matches the CF on the front console perfectly...
Installation instructions:
Step 1- Remove inner rubber piece of cup holder
Step 2- Remove both torx screws from bottom of cup holder
Step 3- Pull up on entire cup holder piece to pop out clips
Step 4- Once cup holder piece is out you can remove factory cubby
Step 5- Factory cubby gator clips on back side need to be transferred to the new carbon cubby before installation
Step 6- Once clips are installed, carbon cubby can be pushed into factory spot
Step 7- Put cup holder piece back into place
Step 8- Fasten both torx screws and install inner rubber piece
Sponsored