What did you do to your Supra today?

Midlifecrisis

Active Member
Joined
Jul 5, 2020
Threads
0
Messages
25
Reaction score
34
Location
USA
Car(s)
2020 Supra Premium - White
I pulled my passengers seat out to clean the Belgian Triple beer that sprayed from the can after It rolled out of the grocery bag and under the seat.. smelled horrible and totally sucked. Lesson learned- put groceries in the hatch and secure it.
 
Last edited:

DrRay81

Well-Known Member
Joined
Jun 26, 2020
Threads
16
Messages
125
Reaction score
180
Location
NOVA
Car(s)
2021 Supra, 2021 Rubicon Diesel
Took the wheels off and gave them a bath. Then washed the rest of the car today. I wasn’t planning on changing the catback but after being underneath the car and seeing the stock exhaust with all the bends and pinched pipes around the diff. I’m definitely gonna be changing it now

A51709E0-12AB-43C4-8D30-A688A3E3D843.jpeg


0753D5B8-080B-4280-BE57-3DAE9284D439.jpeg
 
Last edited:

MYNEWFAST

Well-Known Member
Joined
May 27, 2020
Threads
8
Messages
106
Reaction score
111
Location
California
Car(s)
2020 Turbulence Gray Supra Premium
I installed a drop in K&N Filter,,
Number 3 3 - 3 1 3 6. I went this route because I am pleased with the factory design of the air box and the cold air Inlet going into the box.. I then
Drove the car around, a lot,, so it could adjust to the new air mass readings.

*I then enjoyed a Grande Green Tea Frappuccino,, from Starbucks. :)
Since there were no superhero duties to attend to.*

Then at night, I found a solid flat wall, paced off 30 ft , and adjusted my headlamps to my liking.
Particularly the driver side.
I adjusted it more to the left, Wider, away from the engine by 3 small 1/4 turns.
"On my car" to move the beam away from the engine compartment U turn the adjuster towards the engine, "clockwise"
and then I adjusted the up/down, "vertical" beam, 3 small 1/4 turns.
For the Passenger side,, I only adjusted the beam up, "vertical "2 1/4 turn.

Now the beam pattern matches the roads, and my field of vision where I like it.
 

a90moe

Well-Known Member
Joined
Nov 9, 2019
Threads
4
Messages
814
Reaction score
805
Location
Earth
Car(s)
MKV Supra
Hi. More info please! It’s kind of hard to tell what you did. Did you cut some holes in the hood as well?
No cutting to hood, cut the plastic vent

Underhood circle pockets are directed to the side vents, so opened up it would vent air

Maybe just a little :rofl: but atleast its not a fake vent now
 

nibble

Well-Known Member
Joined
May 21, 2020
Threads
47
Messages
1,255
Reaction score
1,141
Location
NJ
Car(s)
BMW, Honda, Toyota
it's just sticker, not actual emblem which is a bit bigger in size.
Yup not level.
had to double check. it's the photo. ;) for some reason. it looks tilted from slight angle either way.. well... it was wopping $10 sticker so I went through guide to make sure it was spaced as in manual and leveled. :D
 
 
Top