See pictures. From east coast supra. Only "damage" is the area where you push a screw driver though to get the air bag off for wheel removal. Originally 850$, asking 500$. Willing to ship. Located in montana
For sale is a brand new AEM charge pipe kit. Purchased this and then went with a top mount turbo and never used. Includes all hardware include T-bolt clamps for the coupler. Retails for 400$ asking 275$
https://x-ph.com/aem-charge-pipe-kit-2020-toyota-gr-supra-bmw-z4-b58-26-3005c/
Per thread title. Used and have since removed. These cover the caps for the oil as well as both coolant reservoirs. No 3M tape needed. Underside is scratched as they were difficult to removed but cannot tell when installed. Set retails for 140$, asking 60$.
For sale is the AFE intake listed above and in the link below. Used for 1000 miles and then replaced with a top mount turbo and no need for an intake. Filter in good condition. The heat shield was slightly modified (drilled two new holes) so it could also fit with the Verus turbo heat shield...
For sale are these carbon fiber covers for the doors where the black plastic is at. Never used. Still has original 3M tape on them. Links to pieces below followed by pictures. Originally 260 for all, asking 150$...
Cusco PowewrBrace Front strut support for sale. All hardware included. Has been hydrodipped to give it a carbon fiber appearance. Has been used for 8000 miles without issues. Switched to a different bracing system and no longer need.
For sale is OEM wheels (like new, no curb rash/rock chips) including Michelin PS tires that came on the vehicle. Removed after 800 miles when my BC Forged wheels arrived. I did powder coat the OEM wheels black. This include TPMS as well. Willing to sell one wheel/tire at a time as well...
Boost Logic port injection plate with 660cc injectors for sale. 800$. Includes hardware for installation under intake manifold. Willing to ship. Used for approximately 2000 miles. switched to CSF manifold with 1050 injectors so no need for this.
Anyone have any good suggestions for the engine cover while using a secondary fuel rail (Port injection). The stock engine cover does not fit in place since the fuel rail moves the intake manifold up and out just a little bit. I can certainly run it with the engine cover off but then the...
I have an AFe air intake and am swapping it out to try the new AWE air intake. However most aftermarket air intakes replace the entire air intake including the afe. However the AWE uses part of the resonator from the stock system which I no longer have. Attached is a picture of the part I am...
Has anyone had this warning come up. When I place the vehicle in reverse a message pops up that states "Parking Assist Malfunction". All the sensors appear to be working appropriately and beep as expected and appear to work appropriately. The message states that the failure is "side...
I have these on the way for my supra which is Nocturnal Black with matte PPF complete wrap.
Front: 19x9.5 +22
Rear: 19x11.0 +38
Plan to wrap with Pilot Sport 4s -
Front: 275/30/19
Rear: 305/30/19
For sale is a Bootmod license, ENET cable and WiFi Adapter. Asking 450$. Switching over to Ecutek and will have the license available later today. Can also sell license without the ENET cable or WiFi adapter. License only 350$. Thanks.
SOLD
I had the AFe catted downpipe on for less than 500 miles. I have now opted for a catless downpipe and that is why this one is for sale. Originally $700. Asking half that - $350. Will ship anywhere in lower 48 for that price. Removing it tomorrow so no pictures but here is the link for...
I am installing HKS lowering springs to eliminate the wheel gap. I would like to keep the stock tires on the vehicle but don't like the two tone premium wheels. I am looking at BC forged wheels. Would you stay with stock sizes (front: 19 x 9 +32 ; rear: 19 x 10 +40) or is there another...