Help: I can not line up rear knuckle bolt and LCA

[What2JZ]

Use the correct size E-torx. You could use a small extension if you don't have a deep. (I guess I didn't have a deep either) My socket fits snug on the bolt. Allows me to maneuver the bolt into the correct angle.

that is what i did for the left side and it worked until it kept slipping off, its an e20, my etorx does not go as far on the bolt as yours it appears fml

Sponsored

 

[What2JZ]

Hey all just wanted to provide an update to anyone interested and future people, I managed to line it up by loosening the LCA on the subframe and using the jack how you regularly would by jacking up the LCA and knuckle. Some how it lined up after 100 attempts. I was not able to horizontally adjust the knuckle like what was mentioned previously but it will see its way through. No need to use a prybar or funny tools, literally just have to hope and pray sometimes.