yeah, itās the grey wire. If it doesnāt work then the splice connection isnāt good. Itās a tight spot and a thin wire so hard to get a good connection with those vampire clip things. My passenger side sometimes flickers sometimes when door opens and closes but I am never on that side. Other than...
Been searching for a secure way to hold my yeti bottle for a bit and this is what finally came to me after reading a thread about mounting a fire extinguisher to the brace behind the seats.
I usually keep the bottle on the passenger seat but sometimes under hard braking the bottle goes flying...
i really like the alcantara, would had done whole thing in alcantara but i wanted to have some differentiation in the wheel, so i added perforated leather to top and bottom. the alcantara looks just as good as when i got it, no pilling or anything, i just make sure i wash my hands before i...
ill need to wait until a wire diagram becomes available because i double checked the splice and the connection looked fine and i only have one gray wire but it isnt gray/yellow. and i dont know which other wire it could be or ground wire. i signed up for techinfo.toyota and there are no wire...
i attempted to do this today but i only have a solid gray wire not yellow/gray. i tried tapping into it but not getting the light to work, does anyone have thoughts or a wiring diagram
I like them so far but have only test drove the car since installing today so I donāt have much use on them yet. Overall I like the snappy feedback and they seem to be built well. I can see the clicky noise getting old after awhile although I use paddles sparingly so I will live with it I think...
bumping an old thread but ever since i got my windshield replaced my passenger wiper will gradually creep up (similar to auto position). I then have to push it down and it will creep back up over time. Wondering if anyone has any thoughts or insight if there is something I can tighten to...
was the original plate originally black/yellow and he just changed the lettering to white or was the plate white as well? is it a vinyl wrap over the entire plate?
i use a proclip base with a quadlock mount on a ball swivel. its definitely secure, only downside is it requires their quadlock phone case to mount, also pricey. i also use the quadlock on my bicycle so it works for me.
OC, CA area and I paid the same, $450 for nano-ceramic plus additional $250 for front windshield. So $700 total. Quite the difference from 7 years ago when I had my wrx hatch tinted for $300 but I assume the material has improved since then. Quality of the install is definitely top notch tho.
I just drilled holes as carefully as I could. Blade might be better at avoiding damage underneath but also might cut a hole too big. For the bottom clips, I used a small Phillips and stabbed a hole cause I couldn't get my drill to fit when angling straight down.
The 3/16 snap grommets are a bit smaller than the single grommet that comes with the net and the tabs are closer to the lip and the lip is smaller in diameter but they worked fine. I have 97 extra in case anyone doesn't want to spend the $10 on Amazon. Just pay for shipping. I'll send 4 in case...