Search results

Has anyone had issues with the oem seats becoming misaligned on their adjustment? My seat height adjust doesn't seem to move in sync between the left and right side of the rails. The left side of the seat will go down further than the right side, but when raising the seat, the left side moves...

Its the BMW piston in bronze Ti with a custom engraving, so $213. The listing isn't that clear, but it comes with a threaded adapter similar to racesengs.

Any BMW shift knob should work, or any BMW shift knob adapter and then any shift knob. As long as the adapter is deep enough for the stalk, or you are willing to modify the stalk. I'm using a lathewerks

Correct, the BMW knob comes with the brass adapter which has 4 set screws on the base. I did notice the adapter doesn't slide over the small nub/ring that the original shift knob locked on to, so it could probably be made to slide a little further down on the lever than I have it if you made...

Yup, with a note on the order for exposed hardware and a groove to tuck/ziptie the boot into. I believe otherwise the shift knob would screw down fully over the adapter and there'd be nowhere to tuck the boot.

My Lathewerks knob finally arrived. Installs the same as the Raceseng.

XSA is also a good alternative to XP if your local club runs it.

Haha, did it show through my post? I thought I was going to just check bimmercode out real quick last night. I'm happy to report this will be a short thread though! Bimmercode support is extremely quick and was able to point me to my OBDLink as the issue while I had been suspecting a bad backup...

I just purchased Bimmercode and wanted to try it out. However the coding failed when writing the ECU and BDC. Backup files are present, but the recovery fails after the progress bar reaches 100%. I am able to code other modules fine, but it always fails to recover the ECU and BDC. I am using a...

Forklifts are natural predators for sure.

Unemployed. Whoops.

Streethunter wing is fantastic to block out cars behind you with their high beams on.

Too many TE37s.

Yup, oem wheels in "fireside copper" with a wet clear coat.

Needs a wash, but she's finally back on the ground.

It's only going to dig deeper if you leave it in...

It took me much longer than I'd like to admit to discover that the A91 rear quarter panel stripes were not an autozone special.

I have a type, and its two doors with long noses.

I like them. Seeing what different stuff people can do with the same car is always cool.

Haha, glad I could maybe help some. Also, in the tracking system mine went directly from waiting on a train to delivered at the dealer with no update in between.