error

After installing SPL parts I went for alignment. Post alignment I am getting below codes. 1: How screwed I am? 2: How can I solve the issues?

I've been having an issue where I cannot seem to use Bimmercode to code the Headunit anymore post installing full screen carplay. I installed full screen carplay from https://easybimmercoding.com/products/toyota-supra-apple-carplay-fullscreen?_pos=1&_sid=2d0ffa624&_ss=r who have stated that...

Anyone had this error before? Firmware versions: (1.30 vs 1.29) Unlocker Connected (0/50 @ E4 65 B8 80 26 D8 ) DME is not ready, please wait ... Connection errors have been detected Please double-check both of the DME connectors Once confirmed, power cycle the Unlocker by disconnecting and...

Ist there any possible way to disable Error Codes on Bimmercode? So it doesnt permanantly pop up on my screen or dashboard?

I was driving town today and got hit with the "TPM Malfunction' error. Attempted to reset TPM twice but recognition would stop at 49%, sit there for 10 minutes, then fail again both times. Got home, disconnected the battery, drove around and now tire recognition is stuck at 0%. Didn't drive...

I have a '23 A91 MT and the JB4 is throwing this code. The description says it's high idle after cold start. I'm running map 2 at the moment and sometimes I experience what I can only describe as rpm hang? In-gear there's very little engine braking. I wonder if it's related.

So, ive had this "restraint system" message on my screen for a few weeks now. This message also comes with an airbag, and seatbelt light on the dash. Now ive seen a good amount of people with either "passenger" or "driver" restraint errors, but this one is just a general "restraint" message...

Hello there i just checked my faultcodes via MHD today and got a Valvetronic error. I can‘t find anything on the internet. The car is running pretty fine. Do I have to worry?

trash site