Search results

No, I did not cut or alter the grills. I used the metal AL sensor mounts and some outdoor clear Goop adhesive. Used some temporary tape under the mount due to the angle shape of the grill, while the adhesive dried overnight, so it did not drip down. Pretty easy and clean looking. Not sure...

Just an informational follow-up on the Al Priority install. I was getting a mystery problem with the system going back and forth from yellow (laser reception) to the blue led (laser jam), while driving at highway speeds. Seems I had the GPS antenna mounted too far under the driver's dash or...

I finished the ALP install. The inside electrical was actually easier than I thought it would be. Installed the controller on driver’s side fender wall and ran the sensor wires to the engine area through that little hole. Had to run the power and ground to the passenger side and use that fuse...

Not yet. My car is getting the clear film applied right now. When I get it back this week, I will attempt the AL install. I found the firewall hole, and the area under the dash install should be pretty straight forward. The center sensor install should be not too bad, but the 2 outer ones...

As to your AL Priority jammer question, I bought 3 standard heads (non-TX) due to the front of the Supra being only about 16 inches high in the center (the sides under the headlights look to be only about 13 inches high maximum, maybe less). The honeycomb grills almost fit the jammer heads...