DIY - 3D printed Supra emblem for Z4 Floormats

[kmf]

Was looking for a simple way to replace the Z4 Emblem on the all weather floormats. Was originally going to print out a sticker, then found the 3D approach resulted in a cleaner look (and quicker to print).

You can find the print sample here:
https://makerworld.com/en/models/1234007-supra-emblem-for-z4-floormats#profileId-1253265

Printed facedown on a carbon build plate to get the effect. Should take about 30minutes to print on the Bambulab P1s.

The Z4 emblem is a sticker that comes off quite easily with a blade, then i glued this one onto the mat.

Sponsored

 

[Tsuki8]

Nice! able to sell me a set?

 

[kmf]

I would have sent you them for free, but I'm on the other side of the world.

You can find the files in the link I shared, if you can find someone nearby with a printer it should take an hour (the cost of material is almost negligible).

 

[Tsuki8]

Think i can accomplish on an ender 3?
What materials do i need?

 

[kmf]

Haven't used on personally, but I don't see why not. Can you do multi color prints?

Aside from that 2 rolls of PLA (other types could probably work as well).

I uploaded the STL to makerworld, if you can't get it of there dm me and I'll send it over.

 

[tbox]

Think i can accomplish on an ender 3?
What materials do i need?

May want to check with your local library too. Many libraries allow their library card holders the ability to 3D print for free.

 

[Vypurr]

I will print a test set and mail them out if they seem decent. I sometimes have issues with uneven lift on the corners of my CF build plate though

 

[i3igpete]

Just a heads up that that is the wrong script. The mkiv has the "blob" a, the mkv has the "pointy" a

 

[Vypurr]

not 100% happy, but will make some adjustments to see if I can get less noticable lines

 

[Vypurr]

@Tsuki8 dm me an address and I'll mail them!

 

[chachaanteng]

@Tsuki8 dm me an address and I'll mail them!

would you make me a set too? I can pay you for them. I just got a set of these mats and have been looking at options. Will DM you too

 

[chachaanteng]

Was looking for a simple way to replace the Z4 Emblem on the all weather floormats. Was originally going to print out a sticker, then found the 3D approach resulted in a cleaner look (and quicker to print).

You can find the print sample here:
https://makerworld.com/en/models/1234007-supra-emblem-for-z4-floormats#profileId-1253265

Printed facedown on a carbon build plate to get the effect. Should take about 30minutes to print on the Bambulab P1s.

The Z4 emblem is a sticker that comes off quite easily with a blade, then i glued this one onto the mat.

Hey what did you use to glue these down? I just printed a set and looking for a good way to make them stick well on there.

Sponsored