Search results

Surprisingly good quality for a $10 button...ha!

I had success after I rolled the supplied putty into a ball and placed on small smooth bottle cap I had...I then pushed that onto the button and pulled back quickly...much more surface tension and the button came right off!

Finally....I actually got it out with the supplied putty...

yeah, I also got the Amazon version as well ...the putty they include is useless...I'll try using blue clay bar

You used a clay bar correct? not the soft putty that was included with button

You used a clay bar correct? not the soft putty that was included with button

And yeah....the putty they include to remove the button is useless...

Just received red start button from Amazon...Here is the difference compared to OE as seen from back side... I noticed there are 3 guides on OE button and I'm not seeing them on red button...Anyone who purchase from Amazon find this to be an issue? OE Start Button (below): Red Start Button...

Here is link to Fire Missile Button

Yes... So much more added storage space now...ha! That space was kinda useless to me anyway since I use the new Supra Proclip Holder for my phone and charge using this USB plug in charger...

:lol:

thanks for posting this... For stock wheel and suspension setup I think the 10mm front / 13mm rear shown above look very well balanced...

This thread should be renamed the "weathertech floor mat domed sticker replace" thread :p

Did you check to see if it's unleaded?

"After application, the bond strength will increase. At room temperature approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90% after 24 hours and 100% after 72 hours." Optimally, the ambient temp should be held above 70F during the 72 hr. setup process... If you...

For those having issue with adhesion what ambient temp are you installing these at?... "The ideal application temperature range is 70ºF to 100ºF (21ºC to 38ºC) for 3M VHB tape... After application, the bond strength will increase. At room temperature approximately 50% of ultimate bond strength...

I'm curious as to why your pulling 5 degrees of timing?? Have you logged knock count to see if this is an issue?

I coded the following a while back and very pleased with everything I've done: Auto On/Off memory - on Active Sound Design - off Start up warning - off Backup camera warning - off Infotainment Screen Dim (Dim Variant) - old

yeah and good luck trying to remove a fine scratch or repair a chip...You'd be better off purchasing a Turbulence Gray and wrapping it in clear self healing Matte film...Ha!