Search results

Domestic defines "real car guys?"

@rennocneb I think you are overthinking the wtrq. It's not an issue with stock turbo. Don't let it hinder your fun. You may need a bench unlock, no biggie these tuners use overnight shipping. They can also lend you a tool to check it first. I highly recommend any catless dp (all the same). Get...

That I am unsure. @MarinTuned may know.

You would have no choice but to buy the methanol and PI it to fully utilize the Pure 800. Unless you are ok with 550whp on 92oct.

@30MilesOffshore do we know for sure the two subs are ran parallel? I was thinking of going Audison and putting in their bmw sub replacement, using it as the woofer for the front 3 way setup.

Wow, very discreet and clean. Keep us updated on the performance or if they're any ways to test and log the signals from that location.

@tadda, where do you pull the schematics from? Looking for some of the usb area so I may route a cord to the glove box.

That is definitely the correct way to be doing this. I am excited to see what the results are. Can you provide details on what speakers and channels you will be utilizing?

To dsp/amp the 8"s you'll need to disconnect from factory amp and connect to the new amp, can't do both. Your installer planning on deleting the factory amp or just high-level inputting the signals to the new amp?

Wouldn't the sound decrease 20% with a crossover, based off another members experience? Do the other speakers play the full frequencies?

I have left over Noico Red 315 from the OE Sub Project Thread. Can I use this in leu of the dynamite around the speaker housing, door panel tube, and door panel?

I drove mine hard off the lot too. Got the refill message after 8500 miles, last change was at 3500.

I had no idea this went down.

Did the JL DSP go well?

Would you mind sharing your speaker wire results?

So Bavsound pretty much said tough luck, not this year. OEM+ states a March release date so I may just go that route.

There was no play in the oem. Everything is tightened and double checked. Both wiggle. I agree there is little room for error. They play rests between the oem button and the plastic piece that slides onto the paddle. Edit: Issue was actually between the ind paddles plastic housing and the...

Any support or ideas @iND-Distribution?

Do these paddles wiggle for anyone else? Mine do if you wiggle them. They don't seem to be an exact fit within the housing on the spring side, there is some play where the light grey tabs go inside the black holes. Are mine defective or is this normal and I was just expecting more from $800...

Yeah they have yet to "get their hands on one" I was told. They have other platforms with higher demand atm. So really everyone that wants one should just start blowing up their feeds with demand.