BM3 + Reflex Plus Problem

[suncty]

I was previously using BM3 custom ROM.

I purchased and installed Reflex+ for higher output.

The harness is TMS.

First, all wiring was connected.

When the engine is started, Flex Fuel is read normally in the BM3 app. (via Reflex+)

However, the temperature of the fuel is abnormally low. (It should be 33 degrees Celsius, but it is displayed as -6 degrees Celsius)

And even if the engine is started, the Engine Speed does not appear, and the values related to can communication in TunerPro RT are not updated.

For example, throttle, etc.

However, in BM3, Flex Fuel is read.

What did I do wrong?

Sponsored

 

[omfgzilla]

Double check your TMS crank position plug. It could be connected to the wrong sensor.

 

[suncty]

Double check your TMS crank position plug. It could be connected to the wrong sensor.

Is there a similar port nearby that uses the same connector?
I think it was placed in the right location on the drawing.

 

[suncty]

Double check your TMS crank position plug. It could be connected to the wrong sensor.

You were right. Thank you.

I was connecting to the wrong place.

 

[omfgzilla]

괜찮아요

Sponsored