Is my ATS Stage 2 Transmission done for? Or something else?

[RichyDaRich]

So I was cruising going about 50mph nothing crazy and my car revs high goes into neutral then of course limp mode I can’t accelerate so I pulled over checked my DTC tool on ECUTEK got a code for CDC10D Enter DFC for ST_GRB_ECU_LP characters turned the car off and then back on limp mode went away got onto the highway did a half throttle shifted fine no slipping all the way to 8th the trans is tuned by XHP and built by ATS I really don’t think the transmission is blown cause ATS is one of the best transmissions you can get on the market. I asked ATS what the code means and said it means it lost the gear shifter signal and to check the connector on the back of the trans make sure it’s locked in. I’m gonna put the car on the lift and check it but I figured I’d ask y'all to see if this happened to anyone else. I’m around 600 WHP(I don’t know the exact number) and I’m on 93.

The mods I have
Top Mount 6870 turbo kit
Port injections
Fuel pump
Heat exchanger
Axles
ATS Stage 2 built transmission

Sponsored

 

[Rocksandblues]

I would check the sensor at the transmission.

 

[suncty]

Check the fault code in the xhp dtc tool.

Sponsored