Lip kit install shops?

[Eman]

Do most of you guys install your lips/diffusers/wings all yourselves? I have a lip kit coming and with the limited time and space I have right now I would much rather have a shop or someone else do it. Any recommended places for this type of install? I’m in the Seatac area.

Sponsored

 

[romanLegion9574]

I did my Rexpeed V2 myself. You should be able to DIY anything attached with 3M in 20-40 minutes. Just marked off the area to fit it with painter's tape, added adhesive promoter to the area, and attached.

I would personally talk to Ivan at Bimtech PNW for drilling, but that can also be DIYed.

 

[Eman]

I did my Rexpeed V2 myself. You should be able to DIY anything attached with 3M in 20-40 minutes. Just marked off the area to fit it with painter's tape, added adhesive promoter to the area, and attached.

I would personally talk to Ivan at Bimtech PNW for drilling, but that can also be DIYed.

yeah. I’ve done a few lips and stuff with factory mounting points on my isf and s2000. But anything with drilling and shaving down I’d rather I have no experience. It’ll be the full Aimgain kit whenever it decides to show up. Like the roof spoiler and trunk lip spoiler shouldn’t be a problem. But the wing and such.

 

[romanLegion9574]

yeah. I’ve done a few lips and stuff with factory mounting points on my isf and s2000. But anything with drilling and shaving down I’d rather I have no experience. It’ll be the full Aimgain kit whenever it decides to show up. Like the roof spoiler and trunk lip spoiler shouldn’t be a problem. But the wing and such.

Not sure about that one. There's factory mounting points for the front lip and side skirts which I'd assume Aimgain uses. As for the Aimgain wing, Ivan might be able to help you out. Look up Bimtech PNW, and you can visit his shop to get a quote. He works on a fair number of the Supras in the Seattle area, mine included.

 

[jtsang25]

Not sure about that one. There's factory mounting points for the front lip and side skirts which I'd assume Aimgain uses. As for the Aimgain wing, Ivan might be able to help you out. Look up Bimtech PNW, and you can visit his shop to get a quote. He works on a fair number of the Supras in the Seattle area, mine included.

Aimgain side skirt requires 6 holes to be drilled on the side skirt. Rear shrowd and front have drill spots to, but also uses factory hardware.

Sponsored