MST V2 Intake Screw Size Help

[ipecacd6]

I bought this intake from a forum member, but when I got it it was missing several of the screws for the install.

The previous owner claims that they re-used the stock air sensor screws, but threads like this specifically say not to do that:

https://www.supramkv.com/threads/mst-intake-install-issue-and-general-intake-question.9647/

Does anyone know if they changed the design at some point to accommodate the stock screws?

If not, if someone could provide the details on what size of hardware to buy to attach the air sensor and heat shield cover, that would be appreciated.

Sponsored

 

[Sgtfluffy16]

I literally ran into this almost exact same problem. The guy who I bought it off of said to reuse the factory screws but the factory screws are an actual screw not a machine screw like what comes with the MST . I bought it used from one of the Facebook groups and of course it showed up with one screw missing for the intake temp sensor, and one screw missing for the lid. I plan to take this tomorrow to get some new matching screws. I can let you know what the size is if you haven't gotten them yet. They're definitely some sort of metric fine thread. I'm guessing an M6 by 1.25 but I'll find out hopefully tomorrow