audi/vw/mercedes wheels?

[Roman]

since we share same bolt pattern can we fit those Germans ?

some of those guys have some nice aggressive setups and sometimes some of those wheels have larger center bores

Sponsored

 

[Hellion]

Absolutely. Any 5x112 wheel in the right offset/width range and a hub bore at or larger than 66.6mm will fit. I've been keeping an eye out for the same thing. TE's have been beaten to a bloody pulp and I haven't found anything in 19 inch yet that I had to have.

Did you have something in mind or just looking to expand shopping options?

 

[black_sedan]

I shopped a lot of used wheels and the only thing I can say is there doesnt seem to be many MB/Audi aftermarket wheels that have good offsets to work on the Supra. Bore can usually worked around with a centering ring if larger.

 

[Hellion]

I shopped a lot of used wheels and the only thing I can say is there doesnt seem to be many MB/Audi aftermarket wheels that have good offsets to work on the Supra. Bore can usually worked around with a centering ring if larger.

Yeah I've found the same. Right width and offset combos hard to come by.

 

[Andrew4Supra]

I would love these for the Supra… (replica BMW M wheel). However the spacing offset and width is the main issue.

https://www.ebay.com/itm/284050786741

 

[Okvilln]

They will work from newer models. Just need spacers. My 20" S5 has the same center bore and bolt pattern as the Supra. Not the same bolt thread though 1.5 vs 1.25. Also Audi's are AWD so it will be hard to find staggered fitment.

 

[Andrew4Supra]

some of those wheels have larger center bores.

aluminum hub centric rings would correct an oversized center bore.

 

[Hellion]

I would love these for the Supra… (replica BMW M wheel). However the spacing offset and width is the main issue.

https://www.ebay.com/itm/284050786741

Exactly. I've always liked a lot of the two-tone machined M wheels. They would look great on the Supra too. I've never been into running wheels I HAD to run spacers to gain proper clearance. Just a preference.

 

[Roman]

I

Absolutely. Any 5x112 wheel in the right offset/width range and a hub bore at or larger than 66.6mm will fit. I've been keeping an eye out for the same thing. TE's have been beaten to a bloody pulp and I haven't found anything in 19 inch yet that I had to have.

Did you have something in mind or just looking to expand shopping options?

I'm not looking at traditional wheels and I agree on TE's and some others. My S2000 had a set of CCW Classics and my 911 had a set of E88's and then Rotiform FUCH's.

so Im checking Vortex, Audizine, local classifieds. Someone was selling a nice set of 20" Rotiform KPS's but I'm not sure about 20" wheels.

I even thought about buying a higher offset 5x114 wheel and then adding adapter because that would bring it down a bit.

I think CB larger then what we need would be OK because we can get those hubcentric rings, but if its smaller then IDK

 

[black_sedan]

offsets arent that bad, but its narrower up front than the factory wheels.

 

[Roman]

offsets arent that bad, but its narrower up front than the factory wheels.

this is what I've found, occasionally see someone with 9.5s up front but its sort of rare

 

[black_sedan]

this is what I've found, occasionally see someone with 9.5s up front but its sort of rare

yep, that ebay set is 8.5" wide up front and the OEMs is 9" wide. wouldnt make sense to go with a narrower wheel and less aggressive offset.

Sponsored