What did you do to your Supra today?

[GarGaMeL05]

It's not lowered and if it were, driving up onto 4 wood pads for example would solve that issue. They're only 3" tall.

Awesome. Good to. know. Thanks

 

[a90moe]

Two fake vents down

Test fit* Its much more clean now

 

[DrRay81]

Took the wheels off and gave them a bath. Then washed the rest of the car today. I wasn’t planning on changing the catback but after being underneath the car and seeing the stock exhaust with all the bends and pinched pipes around the diff. I’m definitely gonna be changing it now

 

[nibble]

tinted Rear lights. DIY also posted here. https://www.supramkv.com/threads/tinting-rear-lights-diy.6313/

 

[MYNEWFAST]

I installed a drop in K&N Filter,,
Number 3 3 - 3 1 3 6. I went this route because I am pleased with the factory design of the air box and the cold air Inlet going into the box.. I then
Drove the car around, a lot,, so it could adjust to the new air mass readings.

*I then enjoyed a Grande Green Tea Frappuccino,, from Starbucks.
Since there were no superhero duties to attend to.*

Then at night, I found a solid flat wall, paced off 30 ft , and adjusted my headlamps to my liking.
Particularly the driver side.
I adjusted it more to the left, Wider, away from the engine by 3 small 1/4 turns.
"On my car" to move the beam away from the engine compartment U turn the adjuster towards the engine, "clockwise"
and then I adjusted the up/down, "vertical" beam, 3 small 1/4 turns.
For the Passenger side,, I only adjusted the beam up, "vertical "2 1/4 turn.

Now the beam pattern matches the roads, and my field of vision where I like it.

 

[dsomegax]

Installed the remaining TRD pieces minus the door trim. Still on the fence on those

 

[DrRay81]

Verus master cylinder brace

 

[JRedMKV]

Two fake vents down

Test fit* Its much more clean now

Hi. More info please! It’s kind of hard to tell what you did. Did you cut some holes in the hood as well?

 

[a90moe]

Hi. More info please! It’s kind of hard to tell what you did. Did you cut some holes in the hood as well?

No cutting to hood, cut the plastic vent

Underhood circle pockets are directed to the side vents, so opened up it would vent air

Maybe just a little but atleast its not a fake vent now

 

[860_ZUPR4]

Is it just me or is the badge not level? looks like it hangs down on the right side

tinted Rear lights. DIY also posted here. https://www.supramkv.com/threads/tinting-rear-lights-diy.6313/

 

[AustinGRSupra]

Verus master cylinder brace

What difference are you noticing? I was thinking of getting the brace.

 

[Paolo]

Is it just me or is the badge not level? looks like it hangs down on the right side

Yup not level.

 

[DrRay81]

Also tinted my tails just like @nibble

 

[nibble]

it's just sticker, not actual emblem which is a bit bigger in size.

Yup not level.

had to double check. it's the photo. for some reason. it looks tilted from slight angle either way.. well... it was wopping $10 sticker so I went through guide to make sure it was spaced as in manual and leveled.

 

[nibble]

@DrRay81 what did you used to paint the exhaust tip? btw, hex tint is the best tail light tint.