Search results

Does this allows air between the lip and the bumper. Can you show a picture that show the gap between the two?

They're not using OEM clutch packs, but i don't know where they're made.

I can honestly say I was a little hesitant buying this. I didn't know if I would be able to do the work, but being in the Army, every base has a diy auto shop with lifts and all kinds of tools. It took me about 26 hours and over 4 days, the shop is only open for 8 hours. Some car was left on...

I'm just seeing this now ?. I'll have to give that a try.

30

I was seeing high IATs after installing the wagner. But that was all due to user error. I didn't know there was a different process for starting the low temp bleeding procedure. And I also didn't follow this where you fill up the overflow tank all the way up to the cap. Once I did i started...

Which manifold do you have? What kind of temps do you see in normal driving and in pulls?

There actually is a procedure, I figured it out a little while ago. Basically the same as the high temp except instead of turning the engine on you step on the gas peddle until you get the service procedure started message. With that being said, do you thing it's still required to do the...

I have a similar issue. I’ve checked for parasitic drain and that’s not the issue. If I put my car in diag mode to load a map I get low battery warning and it will eventually cut out of diag mode. If I don’t drive the car for a couple days it will attempt to start on the first press, but then...

Thanks for the tip. I’ve been doing some research and realized when I installed the intake manifold I did the bleed procedure for the radiator and not the manifold.

Did you ever figure out the low temp side procedure?

now that I think about it, the guy kept the hood closed and didn’t have any fans running during the Dyno. But would that account for a loss of that much power?

ambient air temp was 62 and I’m using Wagner manifold.

I did hit 115 IAT towards the end, so I don’t know how much heat affected the numbers. I believe that Dyno is reading very low. I used the same Dyno when I was on JB4 Jesse tune, dp, and ethanol and on that same Dyno hp/tq was about 425/450 when people with that same setup were seeing around...

Did you ever do the transmission build? Any tips?

That’s the one issue I had in the back of my mind with it using the torque reported in MHD. It is smart enough, after I told it, to convert the NM to Lb-Ft. I fun messing with the ai and trying to get it to understand my questions and reforming my questions so it can understand what I want. I...

I’m using MHD.

Turbo: Drift Motion stage 3. other mods: catted dp, charge pipe, intake, pi with Wagner mani and 980cc injectors, pfs lpfp, meth injection, e45, and Reflex +. Currently remote tuning with Fabian at Pureboost. I will Dyno when complete. For shits and giggles I uploaded logs into ChatGPT and...

I wasn’t expecting the pump to be so noisy, anyone else have similar experience?

After two hours of screwing with that sensor, I got it off in two seconds. Here’s what you do, lay across the engine bay from the passenger side reach in and squeeze and pull off. It’s that simple.