Search results

OilFeed restrictor generally depends on bearing type, not wheel diameter. Ball bearings need a restrictor or pressure regulator, journal bearings will generally gulp as much oil as you can feed it, since oil is intended to go over, around, and through the floating bushing.

lifeguard 8 is used for 8 speed transmissions and lifeguard 9 is used for 9-speed Transmissions? 🤯

I notice. Wheels and lug pattern need to have a common denominator, otherwise they look unbalanced to me. 6 spoke wheels look weird on 5-lug cars because of the anti-symmetry. Same with 5-spoke wheels on 4-lug. 5 spoke obviously looks good on 5 lug. 6 spoke looks good on 4. 10-spoke can run on...

Looks like a unflattened version of the 4-cylinder wheels. Which, until right now, I thought they were the same.

Unlike other tow hooks or tow straps, this is a single piece design. There is no joining bolt or pin to break. The threaded STEEL shaft is permanently sewn into place. These are not mere show pieces, they are intended to recover your car out of the sand trap. I Paid 270 for the pair. You...

I would just grab a neighboring screw and head to a bmw dealer, they probably buckets of replacements

Not having much luck trying to find the front tire spats/blockers/etc. Here's a link if someone else wants to give it a shot. https://parts.woburntoyota.com/Toyota_2026_GR-Supra-30L-6-cylinder-MT-MkV-Final-Edition-Hatchback/Body.html...

Sold

Sold

No aux battery in the front for my car, I've been in that windshield wiper/battery terminal area multiple times. From the AI response you pasted , it only shows up in the z4 30i. The other link it provided was a total hallucination from a Dodge Ram cargo van Facebook page. Come on, are we not...

Oh, yeah if it's the aftermarket electrical that is leaking - that has plagued pump vendors for decades. For years we struggled with fuel wicking along the wire sheath, even with cable gland fittings. They make liquid tight bulkhead studs, which look like what you have there.

Split o-ring gasket is not unheard of, jackie ran into issues with that. He noticed the fresh o-ring was quite a bit smaller so it fit much more snugly.

No, the charge pipe and manifold sensors would give correct pressure readings regardless of a pre-turbo leak. Additionally, the preturbo temperature sensor (its not a MAF sensor on b58tu engines) gives the same reading whether it sees 100% or 10% of the incoming air.

As great as the BMW valvetronic system is, the aftermarket companies still haven't caught up. That's why aftermarket cams on this engine typically only get you a half mm more Maxlift. The intermediate lever is the limiting factor, and as far as I know, nobody makes a replacement. If you stick...

A 900-hp rated turbo will get you to 600whp on pump gas, but there are some caveats. Ideally, you'd want to pick the compressor wheel thats at peak efficiency very near redline. The omega 65 fits the bill on the compressor side, but the "hybrid-like" design (big compressor, small turbine) is...

That thing you circled is not the charcoal canister. Its a diaphragm that smooths out the flow of fuel vapors. Here is a diagram of the charcoal canister connections

Pair (two) seat belt extender, regular 7 inch black. Useful if you switch to a bucket seat and are retaining your oem seat belt for street driving. I paid 40 bucks for the pair. You pay 25 bucks shipped (within the US).