Magnaflow fitment

[Yabai]

Installed mine today with help from a friend (highly suggested). Fitment was dead on, sound great. I went with 3” inlet and both mufflers. There is a noticeable vibration/resonance from the exhaust right off idle but does completely vanish above 2000rpm.

Not sure if going to 3.5” pipe would help, hinder, or be completely indifferent in helping that.

the only issue with install (other than needing 4 hands) was The chassis brace was sitting on exhaust pipe. But I just shimmed down the brace about 1/4” in the middle and all was well.

can you take pics of the exit pipes? I've tried adjusting the plate and still can't get the right side centered.

by shimmed do you mean like sanded it down?

Sponsored

 

[Last Lemming]

No, I’m talking about the engine brace that you have to take down to install the system. I had to put four oversize nuts above the engine brace so that it moved it downward so it wouldn’t hit the pipe anymore. This would not help with your centering of the exhaust.