Maxton V4 front lip - Excellent product A+

[Lilhercules07]

Very happy with the quality and fit of this product. I will say the installation instructions were useless! I had to drill all the holes myself and used different hardware. Well worth the extra effort. ?

Sponsored

 

[Allenyao09]

Cool. How hard is it to install the front lip?

 

[travsam89]

I just ordered this one myself

 

[Lilhercules07]

Cool. How hard is it to install the front lip?

Took me about an hour. Jacked the car up, drilled 8 holes and used metal screws. I did not remove the large under tray as it wasn’t necessary IMO

 

[Extreme Power House]

 

[Han_Supra]

Did you receive yours with any scratches? I've received two of them scratched on the front of the lip, underneath the protective covering.

 

[Supraman40]

Does this allows air between the lip and the bumper. Can you show a picture that show the gap between the two?

 

[puzzled]

I used well nuts to install my V2.. Acehardware sells them. It will take a bit longer to install, but installed properly.

 

[Loco38SUP]

I used well nuts to install my V2.. Acehardware sells them. It will take a bit longer to install, but installed properly.

Nice, I used teflon lock nuts from the back side. No way I was risking it coming off at 150mph and going through someone’s windshield behind me.

The double sided tape and self tapping screws didn’t seem strong enough for my liking.

-RJM

 

[lucky phil]

Nice, I used teflon lock nuts from the back side. No way I was risking it coming off at 150mph and going through someone’s windshield behind me.

The double sided tape and self tapping screws didn’t seem strong enough for my liking.

-RJM

Well nuts are a very good option and if installed correctly the lip won't detach even at 150mph. Some of my track bikes use well nuts to hold the entire fairing on at speeds well over 150mph. No issues at all.

Phil

 

[NOCTURNALDEATH]

Very happy with the quality and fit of this product. I will say the installation instructions were useless! I had to drill all the holes myself and used different hardware. Well worth the extra effort. ?

Just got mine and im stumped on where to even drill the rest of the holes. I got 4 of the holes drilled to line up with the oem fasteners and bolts. Can you pls pls pls drop a pic of where you drilled the rest?

 

[NOCTURNALDEATH]

Took me about an hour. Jacked the car up, drilled 8 holes and used metal screws. I did not remove the large under tray as it wasn’t necessary IMO

How did you do it?? Im stumped on where to even drill or place the holes

Sponsored