New TPMS - how much torque when installing them?

[jchadwell]

Picked up a set of these for my autocross wheels:

https://www.tpms.com/Toyota-Supra-Huf-IntelliSens-TPMS-Set-WAA01-p/uvc0077set-toyota-supra.htm

Does anyone know how tight they should be? Is snugged down pretty good by hand about right? I don't want to break them by over torqueing but don't want them coming loose either.

Thanks in advance!

Sponsored

 

[KBG]

Couldn't find actual torque specs but in searching for the black plastic collar on my new sensors I came across this:
"The valve stems are the updated versions, no spacer ring required/you just have to keep tightening the collar nut/eventually break loose and thread together"

 

[Im_Bradical]

Itll say on the box/bag with the sensor. Probably around 35-40 inch pounds. It's not much

 

[jchadwell]

Itll say on the box/bag with the sensor. Probably around 35-40 inch pounds. It's not much

Thanks but there's nothing on the box and no instruction sheets in the boxes either. I've actually never seen torque expressed in inch-pounds before so, yes, that wouldn't be much. Sounds like pretty snug by fingers will do the job.

 

[starman]

I ordered black stems and I'm looking at original TPMS Valve Stem Huf Bag right now and it is in fact 4Nm \ 35 in-lbs

Sponsored