Lowering Springs

[jnoremac]

Hi all,
I have been looking to lower my Supra and have been leaning towards the Eibach EU springs (PN E10-20-046-02-22). I am looking for a subtle drop where I won't be scraping everywhere while still having a better fitment overall. I have seen a couple of people say to get the Z4 s30i compatible springs instead of the Z4 M40i for the more accurate spring rate and am unsure how to proceed. I am also going to be running 13mm spacers in the front and 15mm spacers in the back with stock wheels and don't want any rubbing or scraping. If someone could point me in the right direction that would be greatly appreciated.
Cam

Sponsored

 

[MaJiC]

I have these springs installed (PN E10-20-046-02-22) as well as the spacer config your describing and I’ve had no rubbing issues. The drop is subtle but still noticeable. Only scraped once in the 3 months I’ve had it installed but that was probably avoidable on my part

 

[Andrew4Supra]

I have the same set up but with 10/13mm spacers. A clean look without being slammed. No issues with rubbing or scraping.

 

[jnoremac]

Thank you for the replies!
Andrew, your Supra looks great on those. I wasn't sure if having less weight in the 2.0 would negatively affect spring rate or make the ride too bouncy since the springs are made for the M40i Z4, or if it's close enough where it won't be a factor.
I also read about you cutting the factory bump stops so I will do that also!

 

[Meraki Autoworks]

Yes thats good.

-Josh

Sponsored