What did you do to your Supra today?

[suicidaleggroll]

Full disclosure, I’ve never seen this particular bolt yet, but, would it be possible to cut off the end so it would be short enough to remove without having to drop the subframe?

I'll let you know when I install them this weekend, I suspect you might be able to do something like that

 

[razorlab]

This is the bolt. I circled it in red in both of the images below:

 

[J29DB03]

This is the bolt. I circled it in red in both of the images below:

Oh, yea, the feasibility of cutting it looks very slim if at all.

 

[Supraboi7]

Why Toyota, why?! Is this the same way on the Z4?

They really bent us over on this one haha

 

[FuzzyRev]

This is the bolt. I circled it in red in both of the images below:

Looks to me like you're dropping the subframe out no matter which way you want to point it, and based on its length, I'd be stunned if it could face the other way without hitting the subframe itself anyways.

 

[suicidaleggroll]

Oh, yea, the feasibility of cutting it looks very slim if at all.

It's hard to say from the angle of that picture, if there's a bit of room you might be able to pull the nut off, push the bolt through until it hits the body, and then use a sawzall/cutoff wheel to cut the head of the bolt off, then push it back through the other way.

I'll be doing the install this weekend so I can look into it more. I have to drop the subframe anyway to install the rear sway, but I'll see how realistic it might be to cut this bolt out before I do.

 

[NFamous60]

The before and after
Thought about side by side but the size difference made it look cheesy and font not the same. Plus with the car having a black and blue theme this fit pretty well for me.

 

[razorlab]

The before and after
Thought about side by side but the size difference made it look cheesy and font not the same. Plus with the car having a black and blue theme this fit pretty well for me.

But it’s not an a91. I don’t get why you would put that on.

 

[wombo]

the bolts holding my spoiler on were apparently rusted out…not sure how it was still holding on.

replaced the bolts with stainless ones, added rubber grommets, and plastic cap that snaps over to look more OEM. Spoiler feels way more solid now!

Where’d you get the rubber grommets from? I need to do this to my trunk to haha

 

[Supraboi7]

Where’d you get the rubber grommets from? I need to do this to my trunk to haha

Got it all from Lowes for super cheap! A very easy yet satisfying upgrade

Btw your Supra looks great, crazy what spoiler and powder coating stock wheels will do!

 

[FuzzyRev]

But it’s not an a91. I don’t get why you would put that on.

 

[frankenm]

got some discs in the mail…

 

[itsbassi]

Got a hood installed, now my fenders don't look out of place lol

I need to go ceramic coat it so the South Florida heat doesn't eat it up quick

 

[Musa_Hanzo]

But it’s not an a91. I don’t get why you would put that on.

Because its a civic si type R

 

[Mimosa]

Where’d you get the rubber grommets from? I need to do this to my trunk to haha

Ace Hardware or any other similar place. Even Amazon has it. Super cheap.

I also installed the A91 Emblem by @SupraMKV2.0. Figured I'd slap it on the driver side fender.

Now the question is... Do I have an actual A91 or not? The world may never know.

What I do know is now my car can run 9's after installing this.