cdrkimball100
Member
Update. This weekend I installed the AMS charge pipe and full MST intake. I reinstalled the original JB+ and the car started with no CEL to my surprise. Went inside to get ready to leave for a drive and when I started the car, CEL was back. I used my buddies handheld Bosch scanner and successfully clred the CEL again. Went on a 20 min drive and the CEL stayed off the whole time. During the next key cycle, the CEL returns and stays. Basically I think the ECM is doing some sort of check at startup and seeing something it doesn't like with the JB+ so it throws the CEL. I am working with Burger to get a replacement unit to see if this clears up the issue. Power seems normal with the car.
With a dp you will get cel. I have the same issue. It says catless dp detected so I'm putting on an 02 spacer to see if it helps
Sponsored