Contactless locking/unlocking (coding)

[iambak]

Sorry for the delayed response, have had a lot going on between traveling and getting sick. As for your answer, unfortunately just manually entering the value 0F did not work for me. I think at this point I need the ncd files from a Supra so I can do some parameter comparisons with my G30 to get to the bottom of this. Unfortunately, I have not found any files online as of yet. I do find it humorous that the pre-lci G30 shares the same systems as the Supra. I do think this platform is where I will find the answers that I have been looking for. I have learned a lot about both the Supra and G30 systems, hence why I have been able to provide a quick and accurate response you help out a few of you. If anyone has these files and are willing to share it with me, please let me know, it would most likely help me out a lot. The platform that I have been using is Bimmer Utility and shares most of its dynamics with Esys. Thank you again RRF985 for your help.

I can export the ncd files for you if that will help you out. It won’t be in the stock state though as I have been fiddling around with coding

Sponsored

 

[dklamac]

I can export the ncd files for you if that will help you out. It won’t be in the stock state though as I have been fiddling around with coding

Thank you iambak, no worries about the stock state, I have an idea of the files that I am looking for. I will be able to do a NCD comparison with Bimmer Utility and hopefully the values that I am looking for will jump out at me. This should also highlight some of the options that I have that you folks do not have and want to help you all out as well. This works both ways, so let me know if there are any options that you are looking for as well and I will do my best to help you out. If you can, PM me the files. Thank you again for all your help with this. Until then take care.

Donny

 

[Penguin74]

I just thought I would add some experience I had with the dim centre screen fix. The information in the spreadsheet didn't work for me but I found another user who found that changing the following setting worked for them.

DIM_CURVE_X2
change value 0x1F 0xC0 to 0x00 0x00

This worked for me. I'm not sure if it is because I have a right hand drive Australian Delivered Supra but this did work for me.

Sponsored