3TMagnetMan
Well-Known Member
- Joined
- Jun 2, 2021
- Threads
- 4
- Messages
- 537
- Reaction score
- 619
- Location
- New Jersey
- Car(s)
- 2021 Supra 3.0 premium
Which rear diffuser do you have?it comes out behind/after the rear axle.
Sponsored
Sponsored
Exhaust Setup Noise Level Comparison Question
- Thread starter MidLifeMK5
- Start date
- Watchers 13
Strych9
Well-Known Member
Just throwing my salt on the pile...
I'm running a 1FS catless and an X-mod.
The 1FS downpipe had 2 good welds on the entire part. They were all good looking welds, just tremendous lack of fusion. I had to redo all of the rest of them. It's fine now. $350 and you get what you pay for.
The X-mod does alright. Sounds decent enough. Could be a little higher pitched but that's just preference. I picked that one because it uses so many v-bands and I planned to remove any section that I didn't like and refab it.
I get a LOT of compliments on how it sounds, but pretty much anyone that wants a Supra is going to think it sounds good. My biggest issue was the absolutely insane drone from 1900-2100rpm (Magnaflowno drone technology). I removed the HH resonator from the valved side and capped the hole, then made a different one for the open side.
The new HH res worked well enough that the exhaust is quieter than the tires while cruising and sport mode off. Not having a HH Res or a straight through on the valved side made it sound a little better and a good bit louder, but man the sound comes alive from 4k-5k. The valve does rattle now on cold start though.
Overall, I wouldn't go for Magnaflow unless you're going to try and have a fabricator solve the drone issue. I also wouldn't go for a 1FS DP unless you want to have a fabricator weld all of it up properly.
I'm running a 1FS catless and an X-mod.
The 1FS downpipe had 2 good welds on the entire part. They were all good looking welds, just tremendous lack of fusion. I had to redo all of the rest of them. It's fine now. $350 and you get what you pay for.
The X-mod does alright. Sounds decent enough. Could be a little higher pitched but that's just preference. I picked that one because it uses so many v-bands and I planned to remove any section that I didn't like and refab it.
I get a LOT of compliments on how it sounds, but pretty much anyone that wants a Supra is going to think it sounds good. My biggest issue was the absolutely insane drone from 1900-2100rpm (Magnaflow
The new HH res worked well enough that the exhaust is quieter than the tires while cruising and sport mode off. Not having a HH Res or a straight through on the valved side made it sound a little better and a good bit louder, but man the sound comes alive from 4k-5k. The valve does rattle now on cold start though.
Overall, I wouldn't go for Magnaflow unless you're going to try and have a fabricator solve the drone issue. I also wouldn't go for a 1FS DP unless you want to have a fabricator weld all of it up properly.
