Magnaflow fitment

[Last Lemming]

Any fitment issues with the Magnaflow Xmod exhaust?

Sponsored

 

[Luckymike]

None...fits perfectly! Sounds even better!

 

[Extreme Power House]

no fitment issues im aware of. Are you have issues with this exhaust?

 

[STV3]

No fitment issues at all. There is a lot of adjustment with in the V bands though, so it does take some trial and error to get everything lined up perfectly. That is if you are as anal as I am and want everything absolutely perfect.

 

[Last Lemming]

No. I just had issues with my Borla fitment so I sold it. Never could quite get it right. I want the Magnaflow but just wanted to verify prior to purchase.

 

[Yabai]

My left side is perfectly centered but my right side is too close to the left side of the bumper. They said they couldn't get the right side centered. They said maybe using the muffled section might get it to center properly. Any suggestions @Extreme Power House ?

 

[MYA90SUPRA]

I don't know if you looked into the remnant performance exhaust or not. It isn't valved so if that's a hard no not to have I wouldn't recommend it. I have it on my car and it was easy to install and has tons of adjustments to help center your exhaust tips. It also gets rid of that choke point after the downpipe on the stock exhaust system where it goes to 3.25".

 

[Extreme Power House]

My left side is perfectly centered but my right side is too close to the left side of the bumper. They said they couldn't get the right side centered. They said maybe using the muffled section might get it to center properly. Any suggestions @Extreme Power House ?

Unfortunately, I don't have much experience with this exhaust as we do not offer it.

My comment was from the forums comments I saw on this exhaust.

 

[Last Lemming]

I see two options. Have the shop cut the bracket holding the two pipes together and reweld once centered, or maybe they can stretch one of the smaller length pipes on one of their pipe machines. Not sure on that second option but worth asking.

 

[Mason]

I use to hear that they rattle a lot. Once I got mine I could confirm.. low rpm makes it go crazy. But doesn’t bother me.

Fits perfectly no issues, sounds great!

 

[Last Lemming]

What’s rattling do you think?

 

[Last Lemming]

Question. Got the exhaust in. Which pipe size are y’all using coming off the DP

 

[STV3]

My left side is perfectly centered but my right side is too close to the left side of the bumper. They said they couldn't get the right side centered. They said maybe using the muffled section might get it to center properly. Any suggestions @Extreme Power House ?

Right where I circled there are 4 bolts with nuts on the back side of them. There's a good amount of adjustment within that plate to center it perfectly. Loosen the ones on the right side and adjust as needed. You may need to adjust the ones on the left as well.

 

[Last Lemming]

Installed mine today with help from a friend (highly suggested). Fitment was dead on, sound great. I went with 3” inlet and both mufflers. There is a noticeable vibration/resonance from the exhaust right off idle but does completely vanish above 2000rpm.

Not sure if going to 3.5” pipe would help, hinder, or be completely indifferent in helping that.

the only issue with install (other than needing 4 hands) was The chassis brace was sitting on exhaust pipe. But I just shimmed down the brace about 1/4” in the middle and all was well.

 

[Mason]

Personally I have the 3.5 no mufflers. It might actually be the 3.5 mid pipe that’s causing the vibration

Sponsored