MHD+ for Supra and Gen 2 B58

[Rowland2004]

your log says 8388608 limiter, which is when clutch slip is detected on MT.

I was wondering when that might happen lol. I have been looking for a clutch that is between the FX1000 and stock.

Sponsored

 

[bushido]

I just installed the MHD flex analyzer and did a quick 2-3 log. I have it set up on the OTS 93 stage 2 and reading 30% E. I know this doesn’t give the same power as running the E30 tune but much easier to put E in and not need to fuss with measuring how much and flash to E30 once content is where I want. Should max timing with little correction.

check your maps again. an E40 flex map should be included..

 

[Rowland2004]

check your maps again. an E40 flex map should be included..

I do see the E40 that will have flex but wanted to see how it did on 93 flex with the clutch limits. Looks like there is no need to push it until i order up a clutch. Just want to find one below the fx1000 since i don't see myself upgrading to a big turbo.

 

[bushido]

I do see the E40 that will have flex but wanted to see how it did on 93 flex with the clutch limits. Looks like there is no need to push it until i order up a clutch. Just want to find one below the fx1000 since i don't see myself upgrading to a big turbo.

totally fair, wanted to inform you since you didn't want to deal with measuring content. sorry bout the clutch!

 

[Rowland2004]

your log says 8388608 limiter, which is when clutch slip is detected on MT.

Was able to get a little more info from CES on this TQ limit on the manual transmissions. Seems like with the OTS tunes that these soft codes that due pop up when limits are hit in the tune parameters. Big thanks to CES.

Still will looking at some clutch options for when i need one.

 

[Rowland2004]

I did some searching on this topic and didn't find anything. But for anyone that is wanting to reset your oil service with map switching enabled. When trying to follow the steps holding the BC stalk button in diagnostic mode it will flash the CEL to change maps and not reset. I tried using the little button on the gauge cluster holding it down and that worked.

 

[tenkyouken]

Is it possible to see your ethanol content without plugging in the adaptor?

 

[Rowland2004]

Is it possible to see your ethanol content without plugging in the adaptor?

I have seen this with BM3 i think where it shows the E content on the HP\TQ screen. I am not aware if MHD has the same ability.

 

[Levanime]

Is it possible to see your ethanol content without plugging in the adaptor?

yes, through MHD+ menu, page3

 

[tenkyouken]

yes, through MHD+ menu, page3

Any way to see how much fuel left in your tank?

 

[Levanime]

Any way to see how much fuel left in your tank?

yeah, fuel gauge

 

[razorlab]

yeah, fuel gauge

 

[tenkyouken]

???

 

[Carbonfibah]

So here’s the question, is jb4 with bef and a custom map 6 better than just suing the mhd+ ots?

also can 21+ use the e40 stage 2+ ots map?

 

[Twisted Tuning]

So here’s the question, is jb4 with bef and a custom map 6 better than just suing the mhd+ ots?

also can 21+ use the e40 stage 2+ ots map?

A piggyback will never be better than an actual flash tune.

Sponsored