Oil level Sensor Problem?

[_ts.mkv_]

I have a 2020 supra that i just recently changed the oil on with the recommended oil by my tuner, 5w-40 Rotella, and after i changed the oil my car will read all the way to 100% when measuring and still say it is at the minimum level and throw a warning after i put in the standard 7 quarts. I have driven it for well over an hour and even added the tiniest bit more of oil just in case. I know the 2020's have problems with the oil level sensor and pressure regulators/pumps but my pressure is reading consistent at 35-50psi while driving around town.

Does this indicate that my oil level sensor has gone bad and needs replacing or is it an entirely different problem?

The car has a catless downpipe, charge pipe, intake, and flex fuel running on an e50 tune.

Sponsored

 

[Jazee]

Did you ever figure anything out for this? I am having the issue on my 2020 where I can't read oil level and I just noticed my peak oil pressure at WOT is around 94-95psi and I read that it should be around 80psi.

 

[_ts.mkv_]

Did you ever figure anything out for this? I am having the issue on my 2020 where I can't read oil level and I just noticed my peak oil pressure at WOT is around 94-95psi and I read that it should be around 80psi.

After a few days of driving it, it just kinda fixed itself. I’m not sure if it was just a glitch or what but mine read around 97 WOT and then when it corrected it went down to about 90 at idle and never gave me another issue.

 

[Branflakes123]

Did you ever figure anything out for this? I am having the issue on my 2020 where I can't read oil level and I just noticed my peak oil pressure at WOT is around 94-95psi and I read that it should be around 80psi.

Check your oil level via an OBD tool, the iDrive method does not allow you to see small changes in your oil level.

Typically if your oil read on iDrive is failing at ~20% that's been indicator of oil pump issues.

 

[a90_don]

Did you ever figure anything out for this? I am having the issue on my 2020 where I can't read oil level and I just noticed my peak oil pressure at WOT is around 94-95psi and I read that it should be around 80psi.

Did you ever get this figured out ?

 

[Jazee]

Did you ever get this figured out ?

My tuner confirmed for me that the Remnant turbo in my car requires a slightly higher oil pressure so I’ve been running with that. No real issues. Still can’t read oil level through the iDrive so I just read it through ecutek.

Sponsored