DrRay81
Well-Known Member
- Thread starter
- #1
So I’ve taken the guinea pig approach here and can tell you for a fact the Injen evo2300 intake will fit as long as you completely seat the air box and then make the intake tube fit the completely seated air box. So on the billet adapter only tighten one clamp. Then assembler everything with the box complete seated then tighten all the clamps. I ordered through @Mod in Japan and they confirmed it should fit but it indeed does clear the strut bars but it’s basically zero clearance unless you mod the strut bar a little. Also the Verus Engineering turbo heat shield will not fit since the manifold changed for the 2021. Hope that helps. Prior to ordering mod in Japan said they’d take it back if it didn’t fit. But Verus has a 15% restocking fee so check the classified if anyone is interested
*so the intake box alone without the tube attached will fit without modding the strut bar. So it is essential to get the intake tube prefect so that the box is completely seated then tighten the clamp. Post edited
*so the intake box alone without the tube attached will fit without modding the strut bar. So it is essential to get the intake tube prefect so that the box is completely seated then tighten the clamp. Post edited
Sponsored
Last edited: