CC²
Well-Known Member
- Thread starter
- #1
Hello all, some quick questions about the Pure800.... I have been told that there is a sensor that is for the pcv system that no longer gets used when the 800 goes on - Can anybody tell me exactly what the sensor is/does? I am aware that the CEL can be turned off with a tune but I just want to know a little bit about it... Is there no way around keeping it in place/in use? During install coolant will be drained, is there any specific method to bleeding the system after refill or can it just be run until t-stat is fully open and heater is blowing hot to purge air?
Lastly, can someone call out the torque specs for the 6 bolts/studs where it bolts onto the cyl head, the downpipe V-Band clamp, and the lower pinch clamp on the bottom end of the DP...? Any bits of advice or tips from anyone who has thrown one on would be appreciated. Thanks!
Lastly, can someone call out the torque specs for the 6 bolts/studs where it bolts onto the cyl head, the downpipe V-Band clamp, and the lower pinch clamp on the bottom end of the DP...? Any bits of advice or tips from anyone who has thrown one on would be appreciated. Thanks!
Sponsored