reNeglect
Well-Known Member
- Thread starter
- #1
I originally really wanted this gauge and had made post gauging interest on it and sending screenshots and everything to Matt at P3 and got the ball rolling on the gauge. But being located in Canada, they had to find someone local to install the gauge and make some install guide and photos while my gauge was in transport/shipping/stuck at customs
But I finally got the gauge earlier this week and I am very happy with it!
While the gauge might look off to some because it’s slanted, in person it just makes sense, as it is angled towards the driver to give it that cockpit view. This really hits my inner ricer as you mash down on the throttle and watch the boost build it really adds to the driving experience.
But probably will be more effective leaving it in IAT mode to monitor temps.
Installation is pretty straight forward, you do have to drill a 1/2 hole underneath the vent to feed the cable through, and P3 does supply a plug with ribbon cable cutout. Im not too concerned by the hole as its under the vent and if you were you uninstall it wouldn’t be noticeable.
more photos available on IG:
But I finally got the gauge earlier this week and I am very happy with it!
While the gauge might look off to some because it’s slanted, in person it just makes sense, as it is angled towards the driver to give it that cockpit view. This really hits my inner ricer as you mash down on the throttle and watch the boost build it really adds to the driving experience.
But probably will be more effective leaving it in IAT mode to monitor temps.
Installation is pretty straight forward, you do have to drill a 1/2 hole underneath the vent to feed the cable through, and P3 does supply a plug with ribbon cable cutout. Im not too concerned by the hole as its under the vent and if you were you uninstall it wouldn’t be noticeable.
more photos available on IG:
Sponsored