xplizitremix
Well-Known Member
- Thread starter
- #1
I seen a few people on the forums who have coded this out for 2020 after installing aftermarket seats / bucket seats which have removed the airbag
Has anyone used pro tool to code sucessfully with pro tool and do you remember what was done especially with the new pro tool layout
Thanks
UPDATE:
these are the codes i'm throwing:
CAS [BDC_G05] | D90D54: NFC reader, inside front: Unexpected CAN user
IHKA [IHKA_G05] | E7140A: Message (FAS status, 0x232) missing, IHKA receiver, BDC-ZGM / SMFA transmitter
AIRBAG [ACSM5] | 9309C4: Driver's seat belt buckle contact: Open circuit
KOMBI [KOMB_J29] | E12C3B: Signal (automatic engine start-stop function status, 0x30B) invalid, transmitter DME/DDE
DSC [DSC_G20] | D354B6: Signal (status, safety belt contact, seat occupancy, 275.6.
invalid, transmitter ACSM
Has anyone used pro tool to code sucessfully with pro tool and do you remember what was done especially with the new pro tool layout
Thanks
UPDATE:
these are the codes i'm throwing:
CAS [BDC_G05] | D90D54: NFC reader, inside front: Unexpected CAN user
IHKA [IHKA_G05] | E7140A: Message (FAS status, 0x232) missing, IHKA receiver, BDC-ZGM / SMFA transmitter
AIRBAG [ACSM5] | 9309C4: Driver's seat belt buckle contact: Open circuit
KOMBI [KOMB_J29] | E12C3B: Signal (automatic engine start-stop function status, 0x30B) invalid, transmitter DME/DDE
DSC [DSC_G20] | D354B6: Signal (status, safety belt contact, seat occupancy, 275.6.
Sponsored
Last edited: