Sponsored

Search results

  1. Code out TPMS error light and warning.

    If only I had created a thread about how to do this... https://www.supramkv.com/threads/disable-active-tpms.21091/
  2. Rear brake not wearing outside of the rotor

    Yea that is correct. I would say brake harder if you haven't yet. It takes some brake force for the rears to fully clamp.
  3. Rear brake not wearing outside of the rotor

    Do you have the pads on the right sides? They have little dimples and are side centric as they align differently in the carrier.
  4. Handling with roll bar? Bolt-on half roll bar recommendation? Debating between Studio RSR vs CMS

    RSR uses rivnuts in crucial places and ONE SINGLE bolt in the rear down bars. Which does not pass any class rules. It's a show car bar at best. CMS isn't triangulated correctly and is basically a mouse trap. Just look at the photo of it below... that thing ain't going to do any good in a...
  5. Razorlab - 2020 LE build thread

    Their bearings have been shown to not be good quality. I'm slowing replacing most of my SPL bits with verkline and others if that tells you anything.
  6. Race Tracking Your Supra - Information exchange

    Bed pads in properly. Think you bed them in properly? Bed them in more. Did you bed them in more? Bed them in more.
  7. SUPRA ULTIMATE B58 JB4 GUIDE AND LOG REVIEW (V1)

    Throttle closed to 24. DME ain't happy.
  8. Drivetrain Warning Issue

    All three are knock sensor related. I would see if it comes back. https://bmwfault.codes/
  9. What maintenance would you do for a 2020 LE that Sat in Showroom Since 2019?

    Trans and diff would be fine. Def brake fluid, engine oil.
  10. Razorlab - 2020 LE build thread

    I try to stay light years away from any thing VTT sells. It's all trash.
  11. Race Tracking Your Supra - Information exchange

    I've run: PMU Club Racers (three sets) CSG C21 Hawk DTC60 Zero issues like this. 60+ track days. Programming change helps with other things, but the shudder has nothing to do with it.
  12. Race Tracking Your Supra - Information exchange

    PMU don't do well with other compounds on the rotor so you need to REALLY bed them in. Like if you think they are bed in, bed them in some more. It's not the pad, the problem is you. ;)
  13. Razorlab - 2020 LE build thread

    Installed a do88 charge pipe to replace my blown apart OEM one. I give the do88 charge pipe a 9/10 on fitment, 9/10 on finish and 8/10 on QC. There were some metal shavings and some bits of metal hanging off the tapped threads inside that I had to do a quick file pass on so there would be no...
  14. HP Increase +50 after oil change (hot climate)

    I will not engage the troll.
  15. Help: Hose Insulation Shredded

    That dealer is marking it up an assload. Stay away from them. It's the crankcase vent hose. Going to assume the insulation is for cold climate to make sure any water vapors don't freeze. MSRP is $53 USD, you can order it online for around $40. Part # Toyota: 12261-WAA03 BMW: 11158693006
  16. Razorlab - 2020 LE build thread

    Last event of 2024 with Masstuning. This wasn't a PB, it was off by .6 seconds but it was the fastest lap of this day. Winter is going to be long... Video, with data overlay!





Top