Need help with suspension clunk after Verus camber plate install

[SilverBully]

I sent mine in to Verus for warranty repair and they replaced the bearings, the new bearings are A LOT tighter in there - the old ones I could move around by hand... I haven't re-installed them yet because it is hot as hell in TX right now, but will try them this fall.

Sponsored

 

[Eastwood]

I have Vorshlag camber plates on KW DDC coilovers, for about more than a year, perfectly quiet.

Then they started making a clunk on weird angles going up/down drive ways to avoid scraping. Eventually the clunk started happening at low speeds in parking lots making turns. I thought it was some spring bind at first but did some more research.

I tightened the shaft nut with an ugga dugga, no idea if it was loose but did it anyway since it was recommended by Vorshlag. Clunk went away but came back after a few drives. So I tightened the shaft nut again, but this time I tightened the camber plate bolts. There's 4 on each side and I would say 3 bolts per side had some light play in them. I think 2 had a lot more play than the others.

Got those tightened down and it's been good ever since. Now I make it part of my maintenance routine to re-tighten those bolts every few months. I also marked them to see any movement.