No, I used the blue paper towel and a plastic trim remover. No scratchesDid you not painters tape the bottom lip/edge of the mirror housing? Brave.
YesDid you self install?
How are those pads working out?Had the catted downpipe & my Z16 pads installed. Very happy with the added sound and power and my wheels are noticeably cleaner after spirited driving.
Any tips? I've got a spoiler coming and am hoping to self install as well.
Triple/quadruple check to make sure the spoiler is sitting properly on the trunk lid. Made sure the spacing was even left/right and also front/back. I propped up the trunk lid with a paper towel roll so that when I drilled I wouldnāt drill in to the trunk deck. The lid is plastic so drilling is easy. After drilling the pilot holes with the template, I switched to a unibit/step drill bit and taped of the drill bit to where I want to stop drilling. Only little issue I had was when initially installing the bolts, the threads on one bolt caught on the little rubber gaskets and caused the bolt to be difficult to tighten. I didnāt try and force it. I just stopped and cleaned up the threads in the spoiler with the thread chaser. Went on fine after that.Any tips? I've got a spoiler coming and am hoping to self install as well.
So far so good. Iāve driven roughly 200 miles and the wheels would usually be covered after the way I drove but there is minimal dust.How are those pads working out?
Did you DIY? I too want to swap out the pads. Iām pretty fed up with cleaning the wheels every two days.So far so good. Iāve driven roughly 200 miles and the wheels would usually be covered after the way I drove but there is minimal dust.
I followed the break in procedure per their website.
Howās the ride quality compacted to stock springs?RS-R down springs! finally no more monster truck
Howās the ride quality been since while cruising around the city and pushing it as well?Love black on yellow. It looks very sporty without the in your face vibe of red cars
Not the original person, but my first time changing the pads on the Supra wasn't too bad. The toughest part was removing the front pads since they are glued on.Did you DIY? I too want to swap out the pads. Iām pretty fed up with cleaning the wheels every two days.
No I had a local shop do them. It took a little over an hour for front & back pads.Did you DIY? I too want to swap out the pads. Iām pretty fed up with cleaning the wheels every two days.
Just out of curiosity, how much did you pay to have a shop install them?No I had a local shop do them. It took a little over an hour for front & back pads.
Iāve driven on them for 6 days now, (with some street racing & hard driving) and they are noticeably cleaner.