What did you do to your Supra today?

[Sloos]

I also activated a lot other stuff. There was also a point xtra boost and some other stuff. But it sounds good. .. of course i activated all. And perhaps i am wrong and my feeling is wrong about. But it feels different when i drive the car. A bit more aggressiv. And i dont mean with that the Sport Plus engine

 

[Escapist]

Did you not painters tape the bottom lip/edge of the mirror housing? Brave.

No, I used the blue paper towel and a plastic trim remover. No scratches

 

[SooopraSD]

Did you self install?

Yes

 

[SooopraSD]

Had the catted downpipe & my Z16 pads installed. Very happy with the added sound and power and my wheels are noticeably cleaner after spirited driving.

How are those pads working out?

 

[Zupra1776]

Yes

Any tips? I've got a spoiler coming and am hoping to self install as well.

 

[SooopraSD]

Any tips? I've got a spoiler coming and am hoping to self install as well.

Triple/quadruple check to make sure the spoiler is sitting properly on the trunk lid. Made sure the spacing was even left/right and also front/back. I propped up the trunk lid with a paper towel roll so that when I drilled I wouldn’t drill in to the trunk deck. The lid is plastic so drilling is easy. After drilling the pilot holes with the template, I switched to a unibit/step drill bit and taped of the drill bit to where I want to stop drilling. Only little issue I had was when initially installing the bolts, the threads on one bolt caught on the little rubber gaskets and caused the bolt to be difficult to tighten. I didn’t try and force it. I just stopped and cleaned up the threads in the spoiler with the thread chaser. Went on fine after that.

 

[Kiske]

Paint matched TRD k/o spoiler was test fitted. Looks great except the waviness of the plastic itself across the topside. I'm not sure if I'm ok with it given the decklid is perfectly smooth in front of it. Don't think I'm willing to take it off, prime/block sand it and repaint it to fix the issue.

 

[Lendo]

How are those pads working out?

So far so good. I’ve driven roughly 200 miles and the wheels would usually be covered after the way I drove but there is minimal dust.

I followed the break in procedure per their website.

 

[NeedCoffee]

So far so good. I’ve driven roughly 200 miles and the wheels would usually be covered after the way I drove but there is minimal dust.

I followed the break in procedure per their website.

Did you DIY? I too want to swap out the pads. I‘m pretty fed up with cleaning the wheels every two days.

 

[bajanstefan]

RS-R down springs! finally no more monster truck

How’s the ride quality compacted to stock springs?

 

[bajanstefan]

Love black on yellow. It looks very sporty without the in your face vibe of red cars

How’s the ride quality been since while cruising around the city and pushing it as well?

 

[Munkeeboi]

Did you DIY? I too want to swap out the pads. I‘m pretty fed up with cleaning the wheels every two days.

Not the original person, but my first time changing the pads on the Supra wasn't too bad. The toughest part was removing the front pads since they are glued on.

I watched a Youtube video and the car still stops after i was done.

 

[Lendo]

Did you DIY? I too want to swap out the pads. I‘m pretty fed up with cleaning the wheels every two days.

No I had a local shop do them. It took a little over an hour for front & back pads.

I’ve driven on them for 6 days now, (with some street racing & hard driving) and they are noticeably cleaner.

 

[WSUPRA]

No I had a local shop do them. It took a little over an hour for front & back pads.

I’ve driven on them for 6 days now, (with some street racing & hard driving) and they are noticeably cleaner.

Just out of curiosity, how much did you pay to have a shop install them?

 

[Lendo]

Just out of curiosity, how much did you pay to have a shop install them?

$180 for pads and $160 for downpipe, I had quotes from indy BMW shops that were $800.