I just installed the Cusco power brace yesterday and have the 3.0 mid pipe on my Magnaflow catback.
Both sides clear the brace by about 3/4" to 1" but I also had clearance with the OEM brace. I'm not sure the 3.5" mid pipe would negate that much clearance though.
What about adding some washers between the bolts and the brace?
the cusco power brace sits lower than the stock one i have the same set upI just installed the Cusco power brace yesterday and have the 3.0 mid pipe on my Magnaflow catback.
Both sides clear the brace by about 3/4" to 1" but I also had clearance with the OEM brace. I'm not sure the 3.5" mid pipe would negate that much clearance though.
What about adding some washers between the bolts and the brace?
I just installed the Cusco power brace yesterday and have the 3.0 mid pipe on my Magnaflow catback.
Both sides clear the brace by about 3/4" to 1" but I also had clearance with the OEM brace. I'm not sure the 3.5" mid pipe would negate that much clearance though.
What about adding some washers between the bolts and the brace?
I have this setup and had occasional rubbing with the power brace that could be heard through the car - really annoyingWhen installing the MagnaFlow exhaust with the 3.5 inch pipes, I had to remove the OEM rear power brace as it wouldn't fit.
Will the Cusco Rear Power Brace fit? Are there any other options?
Should double check as it fits fine. Something has to be off.When installing the MagnaFlow exhaust with the 3.5 inch pipes, I had to remove the OEM rear power brace as it wouldn't fit.
Will the Cusco Rear Power Brace fit? Are there any other options?