Sponsored

Trunk door not opening :(

Loco38SUP

Well-Known Member
Joined
Feb 17, 2021
Threads
55
Messages
2,348
Reaction score
3,402
Location
Seattle
Car(s)
2021 GR Supra 3.0 (Renaissance Red)
OP
OP
chenqiju

chenqiju

Active Member
Joined
Dec 5, 2020
Threads
2
Messages
27
Reaction score
16
Location
Los Angeles
Car(s)
Honda

Loco38SUP

Well-Known Member
Joined
Feb 17, 2021
Threads
55
Messages
2,348
Reaction score
3,402
Location
Seattle
Car(s)
2021 GR Supra 3.0 (Renaissance Red)
I prefer to tape than putting a rubber. I don't wanna break the emergency handle when I really need it.
Tape works also but it looks bad. The little rubber plug removes easily with a swipe of your hand. It takes 1 extra second to remove before pulling the handle.

-RJM
 

SupraYYJ

Well-Known Member
Joined
Jan 28, 2020
Threads
4
Messages
419
Reaction score
996
Location
Victoria, BC, Canada
Car(s)
2021 Toyota GR Supra 3.0
I prefer to tape than putting a rubber. I don't wanna break the emergency handle when I really need it.
Wait, what? You're planning to be trapped in the back of your Supra at some point?? How would you even do that???

Pics of a reenactment would be very appreciated. Double points for video. Thanks.
 
OP
OP
chenqiju

chenqiju

Active Member
Joined
Dec 5, 2020
Threads
2
Messages
27
Reaction score
16
Location
Los Angeles
Car(s)
Honda
Wait, what? You're planning to be trapped in the back of your Supra at some point?? How would you even do that???

Pics of a reenactment would be very appreciated. Double points for video. Thanks.
I will show you how that happen under the water. JUST need some shots~
 

ericchen_ec

Well-Known Member
First Name
Eric
Joined
Jan 25, 2023
Threads
18
Messages
112
Reaction score
74
Location
Virginia
Car(s)
2020 Supra
I had an issue with the emergency release getting loose and jammed in the trunk when closing. It actually broke the emergency release lever off internally in the latch. It’s made of plastic. I was able to get the trunk open by crawling through the front into the trunk and following steps 1-2d in this post. After 2d I was able to unbolt the striker. and pull out the striker with the bottom panel. Then I was able to access the bottom of the trunk and pull out the latch.

https://www.supramkv.com/threads/blackvue-dr900s-2ch-install-diy.4921/

A90B2827-4C13-49FE-B673-3A2091F911C6.png
I have been added to the list... Will be trying this. Should any parts be replaced as preventative if I get it to open, or is it just an unfortunate moment but no harm
Sponsored

 
 








Top