What did you do to your Supra today?

BluePhirePB

Member
First Name
Perry
Joined
Dec 2, 2019
Threads
0
Messages
18
Reaction score
8
Location
Ontario, Canada
Car(s)
2010 Toyota Matrix, 2016 Toyota Corolla
Vehicle Showcase
1
You have a lift but you are hesitant about oil changes? I'm not being critical here, more curious, how is that possible?
I don't blame you for making fun of me.

I got the lift for storage reasons but one perk I didn't fully realize until I got it installed was being able to fully inspect/observe the under carriage. I saw where the circular hatch is to get to the oil drain plug. Then I saw videos on how the oil filter location is above, to the right of the engine cover. O-ring should be replace at the plug and filter and you fill 6.7L. Then run the car for 10 minutes to perform the oil levelling procedure. Despite knowing this, I worry I'll screw it up.
 

RadioActive

Member
Joined
Jul 8, 2025
Threads
0
Messages
24
Reaction score
59
Location
Texas
Car(s)
2026 Toyota Supre FE; 2015 Lexus IS350 F-Sport
Front reflector delete, DivineDrive intake mod, spacers, and wheel center caps. I ran out of shop/lift time to finish the rear reflectors and get to the differential brace. Will be lowering in the near future as well. Also while done in the past but added some carbon dress up pieces.

IMG_4869.webp


IMG_4867.webp


IMG_4873.webp


IMG_4838.webp


IMG_4835.webp


IMG_4833.webp
 

itzTang

Well-Known Member
Joined
May 17, 2023
Threads
2
Messages
807
Reaction score
777
Location
Socal
Car(s)
2024 Supra 3.0
Front reflector delete, DivineDrive intake mod, spacers, and wheel center caps. I ran out of shop/lift time to finish the rear reflectors and get to the differential brace. Will be lowering in the near future as well. Also while done in the past but added some carbon dress up pieces.

IMG_4869.webp


IMG_4867.webp


IMG_4873.webp


IMG_4838.webp


IMG_4835.webp


IMG_4833.webp
you might want to adjust the front bumper a bit more on the side
 

i3igpete

Well-Known Member
Joined
May 16, 2022
Threads
44
Messages
1,254
Reaction score
1,484
Location
Chicago
Car(s)
2023 3.0L 8AT
Sparco circuit ii is a confirmed fit with pci sliders. The shoulder bolster barely touches the door card, but you can slide a piece of paper between. There is a finger gap between the seat and the tunnel so in theory I could shift it over, but I don't really feel like it.

1000021306.webp
1000021300.webp
 
 
Top