Supra Development Thread - OEM Plus Mods

[Mayday]

Any plans on making OEM single exit diffusers?

Sponsored

 

[stormgreysupra]

Any plans on making OEM single exit diffusers?

It would be too expensive to develop and we already have exhaust cutout covers available that do the job pretty nicely.

 

[BMWAF]

Steering wheel badges in the works with S and Supra logos!

Will this slip over or replace the original? Also, if it replaces it, how is the original removed?

 

[stormgreysupra]

Will this slip over or replace the original? Also, if it replaces it, how is the original removed?

it will replace the original emblems. You will have to take off the airbag and the airbag cover to swap them

 

[dBunny]

After steering wheel badge, engine cover badge next?

Would like to get both.

 

[stormgreysupra]

After steering wheel badge, engine cover badge next?

Would like to get both.

yes that’s something we will look into after

 

[BMWAF]

it will replace the original emblems. You will have to take off the airbag and the airbag cover to swap them

Ugh.. Too much effort for me - May as well replace the whole steering wheel at that point. An S would look nice but I'm too busy looking at the road in any case.

 

[stormgreysupra]

Ugh.. Too much effort for me - May as well replace the whole steering wheel at that point. An S would look nice but I'm too busy looking at the road in any case.

We also have custom leather and alcantara airbag covers. I think it will make the most sense to replace at least the airbag cover with a custom one and add the badge.

But we can also get you a custom full steering wheel

 

[stormgreysupra]

Steering wheel badges

 

[SCZ4]

Out of interest, did you ever come up with a solution for replacing the fake vents behind the doors? I remember it was briefly mentioned a while back.

 

[stormgreysupra]

Out of interest, did you ever come up with a solution for replacing the fake vents behind the doors? I remember it was briefly mentioned a while back.

We will work on replacements but the new ones will still be fake, it will just look different. There’s no way to make them open.

 

[SCZ4]

We will work on replacements but the new ones will still be fake, it will just look different. There’s no way to make them open.

Look forward to seeing what you come up with.

 

[stormgreysupra]

Look forward to seeing what you come up with.

I will share the design ideas here

 

[BA9092]

The way it should have come from factory.

Any update on these?

 

[stormgreysupra]

Any update on these?

We are starting the mold at the end of this month.

Sponsored