racebuild
Well-Known Member
Manufacturer of the arm didnât design with having ease of adjustment in mind. I would extend the inner joint so the jam nut sits right on the edge the pocket of the subframe. You have to double check shank length to see if you can run one side extended and still have enough thread engagement. From the photos posted, it looks like they have the outer joint extended further so there is some wiggle room. If not measure out the heim and order the correct length heim.Yeah the outers i'm not concerned about, it's the inner that we couldn't get from any angle. With the cover off you can KIND OF get the inner jamnut with some angled long-nose needlenose pliers, but you certainly can't get any kind of real torque on it. Unless you freeball it and leave the inner loose and only jam the outer nut.
Sponsored