suicidaleggroll
Well-Known Member
Thanks for posting that info in the other thread. I ended up following in your footsteps and put the exact same setup in mineProClip here, using a somewhat custom combination of parts from them. I left some details in a different phone mount thread, but will repost here:
ProClip MagSafe Mount
I wanted to have the phone closer to the driver, near the emergency lights button. Also wanted to avoid having the vents blow directly on the phone, which this generally solves. By itself, the mount had the phone a bit high which caused it to block part of the infotainment screen. Was able to solve with a combination of hardware:
Supra Angled Mount
https://www.proclipusa.com/product/855595-angled-mount
MagSafe Mount (FYI if you have 12 Max you may need a different mount)
https://www.proclipusa.com/product/iphone-holder-for-magsafe-charger
Small Left/Right Extension Plate
https://www.proclipusa.com/product/215395-left-right-extension-plate
15 Degree Wedge
https://www.proclipusa.com/product/215964-15-degree-wedge
The wedge both helps angle the mount towards the driver and gives enough clearance for the extension plate to fit. Hard to reach a few of the radio preset buttons but I don't really use most of them.
Part of the reason I went for this setup is that with my current phone case it is kind of a pain to slide the phone in and out of the built-in charging tray area. Also, like being able to use Waze/Maps on the car screen and have music playlist / controls on the phone.
Sponsored